![]() |
|
||||||||
![]() |
|
![]() |
![]() |
![]() |
![]() |
![]() |
|||
![]() |
![]() |
![]() |
![]() |
![]() |
|||||
KWIK-FLEX Low Temperature Expansion Joint Repair Material KWIK-FLEX
is a unique and complete expansion joint repair material designed
for use in low temperature areas or anywhere a quick set is desired.
KWIK-FLEX cures to a high strength, resilient, and long lasting seal
in just 60 minutes. KWIK-FLEX can be applied under low temperature
conditions without the usual need of heat lamps or propane torches.
KWIK-FLEX remains serviceable to -60°F. KWIK-FLEX may also be
used for slip joints or as a crack filler.
Key Benefits Repairs expansion joints and slip joints. Properties Pot life @ 75°F available in two set times: Surface Preparation Sawcut must be clean and free of any film, dust, grease, and oil. Foreign matter should be blown out using oil free compressed air.
For a level loop: Pour a quantity (half a gallon is recommended) of the liquid into a clean container (plastic is preferable). Gradually add the powder (approximately 7.5 lbs.) to the liquid, stirring constantly until a uniform consistency is achieved (similar to pancake batter). For a loop on a grade: Follow the same directions as above except add slightly more powder to make a stiffer mix to prevent the sealant from flowing out the bottom of the sawcut. Do not mix more than can be used within the pot life of the material. When applying KWIK-FLEX, allow material to flow slowly into the loop sawcut and self level. KWIK-FLEX may be applied to damp surfaces as well as surfaces below freezing. Caution Keep away from heat and open flame. Avoid prolonged contact with skin
and breathing of vapor.
Home | Contact Us | Kwik-Bond | Kwik-Flex | Repox-Mix | Retrax | Citra Crystals | Polyflex | Repox-FC | Repox-HB | VO-500 |
|||||||||
|
|
|||||||||
|
|
|
|
|
|
|
|
|
|
|